microcontroller:esp8266:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| microcontroller:esp8266:start [2022/03/03 11:40] – illu | microcontroller:esp8266:start [2022/03/03 11:48] (current) – illu | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== ESP8266 ====== | ====== ESP8266 ====== | ||
| + | |||
| + | i bought some nice esp8266 version 01 from ali | ||
| {{: | {{: | ||
| + | |||
| + | with an CH341 serial uart usb adapter to programm with the arduino ide. u can use this driver or search through google. | ||
| + | {{ : | ||
| {{: | {{: | ||
| + | |||
| + | for uploading code, you need to ground gpio0 and gnd to get the esp into program mode. | ||
| + | i just used some staple pins to connect each other, sure better is a resistor, but the pins where too fat: | ||
| {{: | {{: | ||
| {{: | {{: | ||
| + | |||
microcontroller/esp8266/start.1646304018.txt.gz · Last modified: 2022/03/03 11:40 by illu